發布時間：2018-06-17 04:01

  本文選題：復合材料 + rGO-MOx　； 參考：《鄭州大學》2017年碩士論文

【摘要】：隨著社會及工業生產的高速發展,產生的有毒、有害氣體的種類及數量不斷增加,氣體傳感器就是伴隨著環境污染的日益嚴重而發展起來的。金屬氧化物半導體氣敏傳感器具有生產成本低、體積小巧、氣敏材料易制備等優點被廣泛應用于氣體檢測,然而選擇性差、工作溫度高等缺點限制了其進一步發展。石墨烯因具有大比表面積、快的電子傳輸速度而被廣泛用于傳感器研究中。本課題主要研究將微量還原氧化石墨烯(rGO)與金屬氧化物半導體材料如SnO_2、TiO_2復合提高氧化物半導體材料的氣敏性能,采用靜電紡絲技術制備氧化物半導體納米纖維,并通過二步水熱法在氧化物納米纖維表面修飾rGO,以及在氧化物納米纖維紡絲制備過程中,直接加入氧化石墨烯(GO),通過后續煅燒合成rGO/氧化物半導體復合納米纖維氣敏材料,系統研究rGO的加入及加入方式對rGO-氧化物半導體復合納米纖維氣敏性能的影響,具體研究內容如下:1.通過靜電紡絲法制備TiO_2納米纖維,通過在靜電紡絲前驅液中加入rGO,調節靜電紡絲參數制備出rGO/TiO_2復合納米纖維,探討了rGO的復合對于TiO_2納米纖維形貌結構以及VOCs氣敏性能的影響。結果顯示,rGO的復合對于材料的形貌及晶體結構未產生巨大影響,并且提高了材料對VOCs的靈敏度。在250℃下,rGO/TiO_2復合材料對于200ppm乙醇氣體的靈敏度達到43.24,是TiO_2靈敏度的22.8倍,其響應時間也較TiO_2納米纖維有所減少。2.通過靜電紡絲法制備純TiO_2納米纖維,然后通過二步水熱法利用rGO對TiO_2納米纖維進行表面修飾,制備出rGO表面修飾TiO_2納米纖維。表征結果顯示rGO使TiO_2表面形貌更加粗糙,但未影響TiO_2材料的晶體結構。氣敏結果表明,rGO表面修飾的TiO_2納米纖維進一步提升了材料的靈敏度,縮短了響應恢復時間。3.利用靜電紡絲法制備rGO/SnO_2復合納米纖維,二步水熱法制備rGO表面修飾SnO_2納米纖維,研究rGO對于其他n型金屬氧化物半導體VOCs氣敏性能的影響。氣敏測試結果表明,rGO的復合以及表面修飾對于SnO_2納米纖維靈敏度提升更加明顯,在150℃下,rGO表面修飾SnO_2納米纖維對100ppm乙醇的靈敏度高達287,并且與SnO_2納米纖維相比,其響應與恢復時間均相對縮短。
[Abstract]:With the rapid development of social and industrial production, the types and quantities of toxic and harmful gases are increasing, and gas sensors are developing with the increasingly serious environmental pollution. The metal oxide semiconductor gas sensor has many advantages, such as low production cost, small volume and easy preparation of gas sensitive materials. The further development of gas detection, however, is limited by poor selectivity and high working temperature. Graphene has been widely used in sensor research for its large specific surface area and rapid electronic transmission speed. This topic is mainly to improve the micro reduction of graphene oxide (rGO) and gold oxide semiconductor materials such as SnO_2 and TiO_2. The gas sensing properties of oxide semiconductor materials are prepared by electrostatic spinning technology. The oxide semiconductor nanofibers are prepared by two step hydrothermal method, and rGO is modified on the surface of oxide nanofibers, and GO is directly added to the preparation of oxide nanofibers. The rGO/ oxide semiconductor is synthesized by subsequent calcination. The effect of addition and addition of rGO on the gas sensitive properties of rGO- oxide semiconductor composite nanofibers is systematically studied with nano fiber gas sensitive materials. The specific contents are as follows: 1. the TiO_2 nanofibers are prepared by electrostatic spinning, and the rGO/TiO_2 composite nanofibers are prepared by adding rGO in electrostatic spinning precursor and adjusting the parameters of electrostatic spinning. The effect of rGO composite on the morphology and VOCs gas sensing properties of TiO_2 nanofibers was investigated. The results showed that the composite of rGO had no great influence on the morphology and crystal structure of the material, and increased the sensitivity of the material to VOCs. At 250, the sensitivity of rGO/TiO_2 compound to 200ppm ethanol gas reached 4. 3.24, 22.8 times the sensitivity of TiO_2, and its response time is less than that of TiO_2 nanofibers..2. nanofibers are prepared by electrospinning. Then the surface modification of TiO_2 nanofibers by the two step hydrothermal method is used to prepare the rGO surface modified TiO_2 nanofiber. The result shows that rGO makes the surface of TiO_2 more surface morphologies. The crystal structure of TiO_2 materials is not affected, but the gas sensitivity results show that the TiO_2 nanofibers modified by rGO surface can further enhance the sensitivity of the materials and shorten the response time,.3. using the electrostatic spinning method to prepare rGO/SnO_2 composite nanofibers, and the two step hydrothermal method to prepare the rGO surface to modify the SnO_2 nanofibers, and to study rGO for other n. The gas sensitive performance of type metal oxide semiconductor VOCs. The gas sensitivity test results show that the sensitivity of rGO composite and surface modification is more obvious for SnO_2 nanofibers. At 150, the sensitivity of rGO surface modified SnO_2 nanofibers to 100ppm ethanol is higher than that of SnO_2 nanofibers, and the response and recovery time of the SnO_2 nanofibers are compared with the SnO_2 nanofibers. All of them are relatively short.
【學位授予單位】：鄭州大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TB33;TB383.1

【參考文獻】

相關期刊論文 前10條

1 Xiao-Feng Lin;Zi-Yan Zhang;Zhong-Ke Yuan;Jing Li;Xiao-Fen Xiao;Wei Hong;Xu-Dong Chen;Ding-Shan Yu;;Graphene-based materials for polymer solar cells[J];Chinese Chemical Letters;2016年08期

2 郭天超;高瑜;韓雪;郭天飛;鄭成娜;李曉;;靜電紡絲法制備二氧化錫基納米纖維氣體敏感材料的研究進展[J];廣東化工;2016年14期

3 楊海貞;徐熠;蔡志江;;靜電紡絲制備聚氧化乙烯復合納米纖維的研究進展[J];高分子通報;2015年07期

4 程磊;彭斯鳴;石明明;;靜電紡絲法制備氧化鋅纖維及其微波吸收性能研究[J];中國陶瓷;2015年03期

5 余稀;但濤;;光學式氣體傳感器的種類及應用[J];電子元件與材料;2013年12期

6 何世堂;王文;劉久玲;劉明華;李順洲;;聲表面波氣體傳感器研究進展[J];應用聲學;2013年04期

7 龐月紅;李朝霞;沈曉芳;錢和;;靜電紡絲技術制備聚苯乙烯/石墨烯復合納米纖維[J];化學通報;2012年11期

8 江創生;陳向標;;靜電紡絲制備生物醫用敷料研究進展[J];合成纖維工業;2012年03期

9 胡茜;葛思擘;王伊卿;李偉;;電化學氣敏傳感器的原理及其應用[J];儀表技術與傳感器;2007年05期

10 史鐵鈞;翟林峰;周玉波;;尼龍66電紡納米纖維膜的纖維分散形態和結晶性能[J];高分子材料科學與工程;2007年02期

相關博士學位論文 前4條

1 鄔洪源;納米二氧化鈦基復合纖維的制備及氣敏性能研究[D];黑龍江大學;2016年

2 秦啟虎;靜電紡絲法制備聚合物復合納米纖維及其功能化研究[D];吉林大學;2014年

3 王海騰;基于石墨烯的鋰離子電池負極材料的研究[D];北京交通大學;2013年

4 張春雪;靜電紡絲制備聚乙烯醇超細纖維膜及其負載藥物的研究[D];天津大學;2004年

，

本文編號：2029575