RF LDMOS功率晶體管的特性分析與模型研究
發布時間：2018-09-12 16:38
【摘要】：RF LDMOS(Radio Frequency Lateral Double Diffused Metal Oxide Silicon)以其增益高、線性好、輸出功率大、穩定性好、價格低廉等優點成為通信基站,射頻雷達中的首選器件。然而國內對于RF LDMOS功率晶體管的研究尚不成熟,本文基于國內研究現狀開展了一款S波段工作的RF LDMOS器件的設計與研制。本文所設計的RF LDMOS晶體管源極采用Trench Sinker結構將LDMOS源極引到P型重摻雜襯底,雙區LDD(Lightly Doped Drain)漂移區結構優化器件擊穿電壓和導通電阻,源極金屬場板調制柵邊緣電場、降低柵漏電容�；诖薘F LDMOS器件的基本結構使用TCAD仿真工具Silvaco進行了工藝仿真。折衷優化了RF LDMOS的比導通電阻、柵氧可靠性和擊穿電壓,確定了器件的Pbody區注入劑量、移區長度、漂移區摻雜分布、金屬場板長度、場板下方氧化層厚度等參數。根據仿真優化設計的的RF LDMOS器件結構進行了流片實驗,器件擊穿電壓為76V,正向飽和電流密度225mA/mm。通過柵極的L型預匹配網絡與漏極的T型預匹配網絡,提升了器件的輸入輸出阻抗。封裝后RF LDMOS的測試結果表明:在工作電壓30V,2.7-3.1GHz工作頻率下,漏極效率大于40%,輸出功率大于100W,功率增益大于10dB,達到預期設計目標。最后,針對所研制的RF LDMOS晶體管開展了電路模型研究。一方面基于RF LDMOS小信號電路模型,使用COLD-FET法提取了器件的寄生參數,通過寄生參數剝離技術得到了LDMOS器件的本征元件參數,經過ADS仿真優化得到了更為精確的LDMOS小信號電路模型參數。另一方面,在小信號模型的基礎上建立了RF LDMOS的大信號模型。其中LDMOS的非線性電流模型的建立以摩托羅拉的MET模型為基礎并進行了適當改進,非線性電容模型的建立借鑒了傳統的經驗公式,模型的擬合結果顯示所建立的大信號模型可以較準確的描述LDMOS器件的電流和電容。
[Abstract]:Because of its high gain, good linearity, high output power, good stability and low price, RF LDMOS (Radio Frequency Lateral Double Diffused Metal Oxide Silicon) has become the preferred device in radio frequency radar and communication base station. However, the research of RF LDMOS power transistors in China is not yet mature. In this paper, a S-band working RF LDMOS device is designed and developed based on the domestic research status. The RF LDMOS transistor source pole designed in this paper uses Trench Sinker structure to lead the LDMOS source pole to the P-type heavily doped substrate. The double-zone LDD (Lightly Doped Drain) drift region structure optimizes the breakdown voltage and on-resistance of the device, and the source electrode metal field plate modulates the edge electric field of the gate. Reduce gate leakage capacitance. The basic structure of the RF LDMOS device is simulated by TCAD simulation tool Silvaco. The specific on-resistance, gate oxygen reliability and breakdown voltage of RF LDMOS are optimized, and the parameters of Pbody region implantation dose, shift region length, drift region doping distribution, metal field plate length and oxide layer thickness under the field plate are determined. According to the optimized design of RF LDMOS device structure, the chip experiment is carried out. The breakdown voltage of the device is 76V, and the forward saturation current density is 225 Ma / mmm. The input and output impedance of the device is enhanced by the L-type prematching network of the gate and the T-type prematching network of the drain. The test results of the packaged RF LDMOS show that the drain efficiency is greater than 40, the output power is more than 100W, and the power gain is more than 10dB at the operating frequency of 30VL 2.7-3.1GHz, which achieves the expected design goal. Finally, the circuit model of the developed RF LDMOS transistor is studied. On the one hand, based on the RF LDMOS small-signal circuit model, the parasitic parameters of LDMOS devices are extracted by COLD-FET method, and the intrinsic component parameters of LDMOS devices are obtained by the parasitic parameter stripping technique. More accurate parameters of LDMOS small-signal circuit model are obtained by ADS simulation optimization. On the other hand, the large signal model of RF LDMOS is established on the basis of small signal model. The establishment of nonlinear current model of LDMOS is based on Motorola's MET model and is improved appropriately. The establishment of nonlinear capacitance model draws lessons from the traditional empirical formula. The fitting results show that the large signal model can accurately describe the current and capacitance of LDMOS devices.
【學位授予單位】：電子科技大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TN386
[Abstract]:Because of its high gain, good linearity, high output power, good stability and low price, RF LDMOS (Radio Frequency Lateral Double Diffused Metal Oxide Silicon) has become the preferred device in radio frequency radar and communication base station. However, the research of RF LDMOS power transistors in China is not yet mature. In this paper, a S-band working RF LDMOS device is designed and developed based on the domestic research status. The RF LDMOS transistor source pole designed in this paper uses Trench Sinker structure to lead the LDMOS source pole to the P-type heavily doped substrate. The double-zone LDD (Lightly Doped Drain) drift region structure optimizes the breakdown voltage and on-resistance of the device, and the source electrode metal field plate modulates the edge electric field of the gate. Reduce gate leakage capacitance. The basic structure of the RF LDMOS device is simulated by TCAD simulation tool Silvaco. The specific on-resistance, gate oxygen reliability and breakdown voltage of RF LDMOS are optimized, and the parameters of Pbody region implantation dose, shift region length, drift region doping distribution, metal field plate length and oxide layer thickness under the field plate are determined. According to the optimized design of RF LDMOS device structure, the chip experiment is carried out. The breakdown voltage of the device is 76V, and the forward saturation current density is 225 Ma / mmm. The input and output impedance of the device is enhanced by the L-type prematching network of the gate and the T-type prematching network of the drain. The test results of the packaged RF LDMOS show that the drain efficiency is greater than 40, the output power is more than 100W, and the power gain is more than 10dB at the operating frequency of 30VL 2.7-3.1GHz, which achieves the expected design goal. Finally, the circuit model of the developed RF LDMOS transistor is studied. On the one hand, based on the RF LDMOS small-signal circuit model, the parasitic parameters of LDMOS devices are extracted by COLD-FET method, and the intrinsic component parameters of LDMOS devices are obtained by the parasitic parameter stripping technique. More accurate parameters of LDMOS small-signal circuit model are obtained by ADS simulation optimization. On the other hand, the large signal model of RF LDMOS is established on the basis of small signal model. The establishment of nonlinear current model of LDMOS is based on Motorola's MET model and is improved appropriately. The establishment of nonlinear capacitance model draws lessons from the traditional empirical formula. The fitting results show that the large signal model can accurately describe the current and capacitance of LDMOS devices.
【學位授予單位】：電子科技大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TN386
【相似文獻】
相關期刊論文 前10條
1 ;今年世界功率晶體管創新高[J];電子產品世界;2011年09期
2 ;功率晶體管突破3GC難關[J];壓電與聲光;1970年03期
3 K.M.古^，
本文編號：2239600
本文鏈接：http://www.wukwdryxk.cn/kejilunwen/dianzigongchenglunwen/2239600.html
最近更新
教材專著
