帶溫度補償?shù)臄U(kuò)頻振蕩器研究與設計
發布時間：2018-09-17 19:40
【摘要】：由于具有體積小、效率高、穩定性好等優點,開關電源已逐漸取代傳統線性穩壓器,被廣泛應用于各類電氣電子設備的供電系統中。作為開關電源的重要組成部分,振蕩器不僅為系統時序和邏輯控制提供同步時鐘,還負責產生斜坡電壓對電流內環進行補償,還間接影響著系統芯片的面積。因此,時鐘穩定性直接影響著開關電源性能的好壞,對高精度片內振蕩器的研究具有極其重要的學術價值和現實意義。在對常見振蕩器結構和工作原理進行分析對比的基礎上,本文選擇了適用于開關電源的張弛振蕩結構。張弛振蕩器輸出頻率容易受到環境溫度、工藝偏差、電壓波動等因素的影響,為了補償時鐘頻率的穩定性,對振蕩頻率進行了公式推導,表明影響頻率穩定性的參數主要有門限電壓Vref、充電電流、比較器失調電壓Vos。在傳統張弛振蕩器的基礎上,本文提出了一種基于失調電壓補償?shù)母倪M(jìn)結構,使比較器門限電壓和電容充電電壓周期性地交換位置,從而削弱比較器失調電壓對時鐘頻率的影響;利用經典的Broken帶隙結構產生基準電壓作為比較器門限電壓,將帶隙電路中IPTAT電流和另一路負溫度特性的電流進行疊加,得到溫度系數為零的基準電流作為振蕩器充電電流,從而實現對振蕩頻率的溫度補償;在充電電容上并聯數個大小依次減半的修調電容,當工藝出現偏差時,通過數字信號控制修調電容是否連接,對電容大小進行步進式調整,從而保證充電電容不隨工藝偏差發生變化,實現對輸出頻率的工藝補償。為了提高開關電源的電磁兼容性能,在振蕩器主體上增加了頻率擴展模塊,通過周期性地改變充電電流的大小,使輸出頻率周期性抖動,時鐘奇次諧波處的頻帶被拓寬,降低了開關電源的電磁干擾(EMI)。此外,為了滿足開關電源在不同工作模式下對時鐘的不同需求,振蕩器還增加了分頻和占空比調節等拓展功能。振蕩器采用0.18 μm BCD工藝具體實現,用Hspice軟件對電路進行直流、交流和瞬態仿真,仿真結果如下:典型工作條件下,振蕩器輸出頻率為500 kHz、占空比為50%的方波時鐘;在-40-125℃的溫度范圍內,振蕩輸出頻率漂移為±0.91%;在三個不同工藝角(TT、FF、SS)條件下,時鐘頻率漂移在1.34%以內;在擴頻模式下,輸出頻率在500 khz的中心頻率處上下抖動,抖動范圍為±6.44%,五次諧波處的頻譜降幅高達12 dB;在降頻模式下,時鐘頻率能進行八分頻,輸出62.5 kHz的低頻時鐘;在占空比調節模式下,可對時鐘占空比向上調節。仿真結果表明,振蕩器輸出頻率隨溫度和工藝偏差漂移較小,在擴頻模式下能有效降低振蕩器的電磁干擾,降頻和占空比調節等拓展功能正常工作,所設計的振蕩器性能穩定、實用性強,適用于各類開關電源管理芯片。
[Abstract]:Because of its advantages of small size, high efficiency and good stability, switching power supply has gradually replaced the traditional linear voltage regulator and has been widely used in various electrical and electronic equipment power supply systems. As an important part of switching power supply, oscillator not only provides synchronous clock for system timing and logic control, but also produces ramp voltage to compensate the current inner loop, and indirectly affects the area of system chip. Therefore, clock stability directly affects the performance of switching power supply, and has great academic value and practical significance for the study of high precision intrachip oscillator. On the basis of analyzing and comparing the structure and working principle of common oscillator, Zhang Chi oscillatory structure suitable for switching power supply is selected in this paper. The output frequency of Zhang Chi oscillator is easily affected by environmental temperature, process deviation, voltage fluctuation and so on. In order to compensate for the stability of clock frequency, the formula of oscillation frequency is deduced. It shows that the main parameters affecting frequency stability are threshold voltage Vref, charging current, comparator offset voltage Vos. Based on the traditional Zhang Chi oscillator, an improved structure based on offset voltage compensation is proposed, in which the comparator threshold voltage and capacitor charging voltage are periodically switched. In order to weaken the influence of comparator offset voltage on clock frequency, the reference voltage generated by the classical Broken bandgap structure is used as the comparator threshold voltage, and the IPTAT current in the bandgap circuit is superposed with the other negative temperature characteristic current. The reference current with zero temperature coefficient is obtained as the charging current of the oscillator, and the temperature compensation of the oscillation frequency is realized. Through the digital signal control whether the modified capacitor is connected or not, the size of the capacitor is adjusted step by step, so as to ensure that the charge capacitance does not change with the process deviation, and realize the process compensation for the output frequency. In order to improve the EMC performance of the switching power supply, a frequency expansion module is added to the main body of the oscillator. By periodically changing the charge current, the output frequency is periodically jitter, and the frequency band at the odd harmonics of the clock is widened. The electromagnetic interference (EMI).) of switching power supply is reduced. In addition, in order to meet the different demands of the switching power supply for clock in different operation modes, the oscillator also adds the extended functions of frequency division and duty cycle adjustment. The oscillator is realized by 0.18 渭 m BCD process, and the DC, AC and transient simulation of the circuit is carried out with Hspice software. The simulation results are as follows: under typical operating conditions, the output frequency of the oscillator is 50% square wave clock with the output frequency of 500 kHz, duty cycle; In the temperature range of -40-125 鈩，
本文編號：2246893
[Abstract]:Because of its advantages of small size, high efficiency and good stability, switching power supply has gradually replaced the traditional linear voltage regulator and has been widely used in various electrical and electronic equipment power supply systems. As an important part of switching power supply, oscillator not only provides synchronous clock for system timing and logic control, but also produces ramp voltage to compensate the current inner loop, and indirectly affects the area of system chip. Therefore, clock stability directly affects the performance of switching power supply, and has great academic value and practical significance for the study of high precision intrachip oscillator. On the basis of analyzing and comparing the structure and working principle of common oscillator, Zhang Chi oscillatory structure suitable for switching power supply is selected in this paper. The output frequency of Zhang Chi oscillator is easily affected by environmental temperature, process deviation, voltage fluctuation and so on. In order to compensate for the stability of clock frequency, the formula of oscillation frequency is deduced. It shows that the main parameters affecting frequency stability are threshold voltage Vref, charging current, comparator offset voltage Vos. Based on the traditional Zhang Chi oscillator, an improved structure based on offset voltage compensation is proposed, in which the comparator threshold voltage and capacitor charging voltage are periodically switched. In order to weaken the influence of comparator offset voltage on clock frequency, the reference voltage generated by the classical Broken bandgap structure is used as the comparator threshold voltage, and the IPTAT current in the bandgap circuit is superposed with the other negative temperature characteristic current. The reference current with zero temperature coefficient is obtained as the charging current of the oscillator, and the temperature compensation of the oscillation frequency is realized. Through the digital signal control whether the modified capacitor is connected or not, the size of the capacitor is adjusted step by step, so as to ensure that the charge capacitance does not change with the process deviation, and realize the process compensation for the output frequency. In order to improve the EMC performance of the switching power supply, a frequency expansion module is added to the main body of the oscillator. By periodically changing the charge current, the output frequency is periodically jitter, and the frequency band at the odd harmonics of the clock is widened. The electromagnetic interference (EMI).) of switching power supply is reduced. In addition, in order to meet the different demands of the switching power supply for clock in different operation modes, the oscillator also adds the extended functions of frequency division and duty cycle adjustment. The oscillator is realized by 0.18 渭 m BCD process, and the DC, AC and transient simulation of the circuit is carried out with Hspice software. The simulation results are as follows: under typical operating conditions, the output frequency of the oscillator is 50% square wave clock with the output frequency of 500 kHz, duty cycle; In the temperature range of -40-125 鈩，
本文編號：2246893
本文鏈接：http://www.wukwdryxk.cn/kejilunwen/dianzigongchenglunwen/2246893.html
最近更新
教材專著
