發布時間：2019-05-19 07:44

【摘要】：在移動通信飛速發展、微波電路高度集成化的今天，微波電路的發展越來越得到重視，微波濾波器在通信系統濾波元件中占據重要位置，，其中，在單片微波電路里，微帶線被稱為其主要載體以傳輸信號，而帶通濾波器在微波電路里發展最為迅速，對于接收機等很多系統，帶通濾波器對其性能的好壞起到?jīng)Q定性的作用，所以對微帶線帶通濾波器進行理論角度的分析、結構方面的研究等都已經成為非常受重視的課題。如今，考慮到無源網絡傳輸信號的可靠性，濾波器相頻特性已經變得和幅頻特性同樣重要，因此，在微波電路的設計中，研究設計線性相位帶通濾波器并加以優化將成為十分有價值的研究項目。 本文首先由歸一化低通濾波器出發，通過分析濾波器的特性，推算出其線性相位設計參數，然后對基于分布參數實現帶通濾波電路的設計原理進行理論分析，在此基礎上完成平行耦合微帶線結構的設計流程和相關參數計算，最后設計一個中心頻率為2GHz的平行耦合微帶線線性相位帶通濾波器。本課題是對濾波器的相頻特性和幅頻特性同時進行優化，并且在得到最優通帶平坦度的同時，使阻帶具有盡量大的衰減。通過設計實例的仿真結果以及經過優化的仿真結果，驗證此方法正確可行、簡單高效。在微帶線優化方面，本文提出了一種新的算法，以理想的微帶線尺寸參數為基礎，建立理想傳遞函數作為目標函數，同時在理想?yún)��?shù)周圍定義取值范圍，將取值范圍內的參數限定在一定數量級精度內，在此范圍內搜索符合條件的參數，并建立各自的傳遞函數，最后將所有傳遞函數與目標函數比較，最接近目標函數的一個為最優函數，構成最優函數的微帶線尺寸參數便是最優參數。在優化結果驗證方面，本文利用與實際電路測試最為相似的矩量仿真方法，對優化后的電路進行板圖仿真，雖然由于時間關系，電路板還在制作當中，但矩量法的仿真結果與實際電路十分接近，可以證明目標函數法有效可行。
[Abstract]:With the rapid development of mobile communication and the high integration of microwave circuits, more and more attention has been paid to the development of microwave circuits. Microwave filters occupy an important position in the filter elements of communication systems, among which, in a single microwave circuit, Microstrip line is called its main carrier to transmit signal, and bandpass filter develops most rapidly in microwave circuit. For many systems such as receiver, bandpass filter plays a decisive role in its performance. Therefore, the theoretical analysis and structural research of microstrip band-pass filter have become a very important topic. Nowadays, considering the reliability of passive network transmission signal, the phase frequency characteristic of filter has become as important as amplitude frequency characteristic. Therefore, in the design of microwave circuit, The research and optimization of linear phase bandpass filter will become a very valuable research project. In this paper, based on the normalized low-pass filter, the linear phase design parameters are calculated by analyzing the characteristics of the filter, and then the design principle of band-pass filter circuit based on distributed parameters is analyzed theoretically. On this basis, the design flow and related parameters calculation of parallel coupling microstrip line structure are completed. Finally, a parallel coupled microstrip line linear phase bandpass filter with central frequency 2GHz is designed. In this paper, the phase frequency characteristics and amplitude frequency characteristics of the filter are optimized at the same time, and the optimal passband flatness is obtained, and the stopband is attenuated as much as possible. Through the simulation results of the design example and the optimized simulation results, it is verified that the method is correct, feasible, simple and efficient. In the aspect of microstrip line optimization, a new algorithm is proposed in this paper. Based on the ideal microstrip line size parameters, the ideal transfer function is established as the objective function, and the value range is defined around the ideal parameters. The parameters in the range of values are limited to a certain order of magnitude precision, and the parameters that meet the conditions are searched in this range, and their respective transfer functions are established. Finally, all the transfer functions are compared with the objective functions. One of the closest to the objective function is the optimal function, and the microstrip line size parameter that constitutes the optimal function is the optimal parameter. In the aspect of verification of optimization results, this paper uses the moment simulation method, which is most similar to the actual circuit test, to simulate the optimized circuit board, although the circuit board is still in the process of making because of the time relationship. However, the simulation results of the moment method are very close to those of the actual circuit, which can prove that the objective function method is effective and feasible.
【學位授予單位】：沈陽工業大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TN713

【參考文獻】

相關期刊論文 前10條

1 郭福成;;基于ADS軟件和通用儀器的通信教學實驗系統[J];電氣電子教學學報;2010年06期

2 李敏;李新陽;姜文漢;;線性相位反演傳感器與哈特曼傳感器的實驗研究對比[J];光學學報;2008年04期

3 王漢江;吳姣;楊維明;陳軍;楊安勝;;基于Richards變換與Kuroda規則的微帶低通濾波器的設計仿真[J];湖北大學學報(自然科學版);2010年04期

4 陳麗艷;劉甫坤;單家方;賈華;李軍;;交指型腔體濾波器設計[J];核聚變與等離子體物理;2011年01期

5 郭湘榮;武岳山;;微波低通濾波器電路設計[J];計算機仿真;2010年08期

6 黃秋元;董詩波;;射頻電路中匹配網絡的設計和分析[J];武漢理工大學學報(交通科學與工程版);2007年06期

7 崔博華;蘇樺;荊玉蘭;;微波濾波器的應用與展望[J];科技傳播;2011年13期

8 龔作豪;沈君鳳;;巴特沃斯低通濾波器的仿真設計[J];信息通信;2014年07期

9 趙承軍;;二端口網絡測試參數的計算[J];計量與測試技術;2013年07期

10 魏啟甫;李征帆;李霖;;一種基于低溫共燒陶瓷的新型多層交叉耦合基片集成波導濾波器[J];上海交通大學學報;2010年02期

相關博士學位論文 前4條

1 彭洋洋;微波/毫米波單片集成收發機中關鍵電路的設計及其小型化[D];浙江大學;2012年

2 吳邊;無線通信中微波濾波器的比較設計法與應用研究[D];西安電子科技大學;2008年

3 高山山;高性能小型化平面微波無源器件的研究[D];電子科技大學;2013年

4 陳佳;微波多通帶濾波器的綜合與設計研究[D];西安電子科技大學;2013年

本文編號：2480528