水量對水性聚氨酯聚集形態及粘接性能的影響
發布時間：2019-02-11 08:20
【摘要】：以聚己二酸1,4-丁二醇酯二醇(PBA)為軟段,以異氟爾酮二異氰酸酯(IPDI)、2,2-二羥甲基丙酸(DMPA)、一縮二乙二醇(DEG)、水為硬段合成了一系列水性聚氨酯(WPUs),探討了水加入量對WPUs性能的影響。通過傅里葉變換紅外光譜測試(FT-IR)、粒徑測試、凝膠滲透色譜測試(GPC)、差示掃描量熱測試(DSC)、X-射線衍射測試(XRD)、熱重測試(TGA)、力學性能測試等對其結構和性能進行表征。通過紅外曲線擬合結果、DSC和XRD測試結果證實,隨著加入體系中水量的增加,氫鍵化N-H伸縮振動峰強度增加,WPUs結晶度降低。隨著水量的增加,乳液平均粒徑增大且分布變寬,同時WPUs的分子量及分子量分布系數逐漸增加;膠膜的拉伸強度和斷裂伸長率均呈現先增大后減小的趨勢,T型剝離強度顯示同樣的趨勢。力學性能測試結果表明,當水加入量為0.94%(wt)時,膠膜的力學性能最佳,拉伸強度達36.7 MPa,斷裂伸長率達1026.5%;當水加入量為0.74%(wt)時,水性聚氨酯的T型剝離強度達到最大值,為1.9 N×cm~(-1)。
[Abstract]:A series of waterborne polyurethane (WPUs), was synthesized by using polyadipate 1-butanediol diol (PBA) as soft segment and isoflurone diisocyanate (IPDI), _ 2o _ 2-dimethylolpropionic acid (DMPA), / diethylene glycol (DEG),) as hard segment. The effect of water addition on the properties of WPUs was discussed. Fourier transform infrared spectroscopy (FT-IR), particle size measurement, gel permeation chromatography, (GPC), differential scanning calorimetry, (DSC), X-ray diffraction, (XRD), thermogravimetry, (TGA),. Its structure and properties were characterized by mechanical properties test. The results of IR curve fitting DSC and XRD show that the intensity of N-H stretching vibration peak increases and the crystallinity of WPUs decreases with the increase of water content in the system. With the increase of water content, the average particle size increases and the distribution becomes wider, and the molecular weight and molecular weight distribution coefficient of WPUs increase gradually. The tensile strength and elongation at break of the film increased first and then decreased, and the T-type peeling strength showed the same trend. The results of mechanical properties test show that when the water content is 0.94% (wt), the mechanical properties of the film are the best, the tensile strength reaches 36.7 MPa, and the elongation at break reaches 1026.5%. When the water content is 0.74% (wt), the T-type peeling strength of waterborne polyurethane reaches the maximum value, which is 1.9N 脳 cm~ (-1).
【作者單位】： 安徽大學化學化工學院安徽省綠色高分子重點實驗室;
【分類號】：O631.11
本文編號：2419553
[Abstract]:A series of waterborne polyurethane (WPUs), was synthesized by using polyadipate 1-butanediol diol (PBA) as soft segment and isoflurone diisocyanate (IPDI), _ 2o _ 2-dimethylolpropionic acid (DMPA), / diethylene glycol (DEG),) as hard segment. The effect of water addition on the properties of WPUs was discussed. Fourier transform infrared spectroscopy (FT-IR), particle size measurement, gel permeation chromatography, (GPC), differential scanning calorimetry, (DSC), X-ray diffraction, (XRD), thermogravimetry, (TGA),. Its structure and properties were characterized by mechanical properties test. The results of IR curve fitting DSC and XRD show that the intensity of N-H stretching vibration peak increases and the crystallinity of WPUs decreases with the increase of water content in the system. With the increase of water content, the average particle size increases and the distribution becomes wider, and the molecular weight and molecular weight distribution coefficient of WPUs increase gradually. The tensile strength and elongation at break of the film increased first and then decreased, and the T-type peeling strength showed the same trend. The results of mechanical properties test show that when the water content is 0.94% (wt), the mechanical properties of the film are the best, the tensile strength reaches 36.7 MPa, and the elongation at break reaches 1026.5%. When the water content is 0.74% (wt), the T-type peeling strength of waterborne polyurethane reaches the maximum value, which is 1.9N 脳 cm~ (-1).
【作者單位】： 安徽大學化學化工學院安徽省綠色高分子重點實驗室;
【分類號】：O631.11
【相似文獻】
相關期刊論文 前6條
1 孫家干;楊建軍;張建安;吳慶云;吳明元;周月姣;;MDI型水性聚氨酯結構及性能的研究[J];中國皮革;2010年19期
2 王高升,余曉峰,汪列敏;無三苯聚氨酯膠中三苯的氣相色譜法測定[J];浙江化工;2001年03期
3 邱麗,孫奉瑞,宮濤;脂肪族水性聚氨酯性能的研究[J];太原理工大學學報;2004年02期
4 詹媛媛;李俊梅;許戈文;;辛癸酸單甘油酯改性水性聚氨酯的研究[J];聚氨酯;2009年11期
5 楊燦;姜京哲;;疏水支鏈水性聚氨酯的制備及性能研究[J];涂料工業;2013年07期
6 ;[J];;年期
相關會議論文 前1條
1 于雙江;曹閱;賀超良;陳學思;;還原敏感聚氨酯交聯膠束藥物載體的制備及性能研究[A];2013年全國高分子學術論文報告會論文摘要集——主題H：醫用高分子[C];2013年
，本文編號：2419553
本文鏈接：http://www.wukwdryxk.cn/kejilunwen/huaxue/2419553.html
最近更新
教材專著
