發布時間：2018-08-09 17:12

【摘要】：為了克服傳統熱壓縮機的不足,提出了一種直線電機直接驅動、以氣缸壁與活塞充當回?zé)崞鞯男滦蜔釅嚎s機系統。利用搭建的實驗裝置,實驗研究了加熱溫度、直線電機驅動功率、工質種類和充氣壓力等對新型熱壓縮機系統運行特性的影響。研究結果表明:采用比熱容比更大的工質有利于提高熱壓縮機系統性能;增大充氣壓力能提高系統內壓力峰值,但效果不顯著。以He4為工質,在充氣壓力為0.96 MPa、加熱溫度為330℃時,新型熱壓縮機系統壓比達到1.14,能滿足特定場合驅動脈沖管制冷機工作的需求;利用帶小孔的氣庫進行了系統輸出聲功實驗研究,發現存在最佳小孔開度使熱壓縮機系統對外輸出功最大;保持工質種類和充氣壓力不變,當加熱溫度為603℃、小孔氣庫容積為0.518L時,實驗測得熱壓縮機輸出功最大為15.6 W。
[Abstract]:In order to overcome the shortcoming of traditional heat compressor, a new type of heat compressor system is proposed, which is driven directly by linear motor and uses cylinder wall and piston as regenerator. The effects of heating temperature, driving power of linear motor, working medium and inflatable pressure on the operation characteristics of the new type thermal compressor system are studied experimentally by using the experimental device. The results show that the performance of the system can be improved by using the working medium with a larger specific heat capacity ratio, and the peak value of the pressure in the system can be increased by increasing the gas pressure, but the effect is not obvious. With He4 as the working medium, the pressure ratio of the new type thermal compressor system reaches 1.14 when the inflatable pressure is 0.96 MPA and the heating temperature is 330 鈩，

本文編號：2174757