發布時間：2019-06-03 19:38

【摘要】：溫拌再生技術越來越受到重視，但是溫拌再生技術中對舊瀝青轉移影響因素綜合考慮的研究較少，國內外對溫拌再生瀝青混合料拌合順序的研究成果不一致，并且國內大都在油石比相同時對不同舊料摻量下的路用性能展開研究。因此，本文致力于溫拌技術中舊瀝青轉移時不同影響因素的研究，溫拌再生瀝青混合料拌合順序的研究和不同舊料摻量對應的最佳油石比下的路用性能的研究。 本文對舊瀝青混合料中舊瀝青轉移程度開展研究時先確定試驗條件，然后考慮不同的影響因素。首先研究不同的集料粒徑對舊瀝青轉移程度的影響，發現集料粒徑對舊瀝青轉移影響不大，其次是預熱溫度�Q拌合時間和拌合溫度對舊瀝青轉移程度的影響，確定出試驗條件；然后是老化時間�Q舊料摻量和粉膠比對舊瀝青轉移程度的影響；最后是再生劑�Q溫拌劑和舊料摻量對舊瀝青轉移程度的影響，找出不同影響因素對舊瀝青轉移的影響規律和影響程度，為后續配合比設計油石比的確定提供依據。 對拌合順序的研究采用宏觀拌合順序和國內外不同的瀝青混合料拌合順序2種方式。宏觀拌合順序不成型試件，用轉移瀝青量作為評價指標；混合料拌合順序采用馬歇爾方法擊實成型試件，，以試件的物理力學指標作為評價依據，結果顯示，2種方式試驗結果一致，建議以后在拌合溫拌再生混合料時采用國內規范規定的拌合順序。 確定不同舊料摻量的最佳油石比，在各最佳油石比下對混合料的路用性能進行研究，結果表明，隨著舊料摻量的增多，熱拌與溫拌表現出來的規律不同，并確定出舊料最佳摻量為20%。
[Abstract]:More and more attention has been paid to warm mix recycling technology, but there are few studies on the influencing factors of old asphalt transfer in warm mix recycling technology, and the research results on the mixing sequence of warm mix recycled asphalt mixture are not consistent at home and abroad. And most of the domestic road performance under different old material content is studied when the oil-stone ratio is the same. Therefore, this paper focuses on the study of different influencing factors of old asphalt transfer in warm mixing technology, the study of mixing sequence of warm mix recycled asphalt mixture and the study of road performance under the optimum oil-stone ratio corresponding to different amount of old asphalt. In this paper, the test conditions are determined when the transfer degree of old asphalt in old asphalt mixture is studied, and then different influencing factors are considered. Firstly, the effect of different aggregate particle size on the transfer degree of old asphalt is studied, and it is found that the aggregate particle size has little effect on the transfer of old asphalt, followed by preheating temperature. The effects of mixing time and mixing temperature on the transfer degree of old asphalt were determined, and then the aging time was determined. The effect of the content of old material and the ratio of powder to glue on the transfer degree of old asphalt; finally, the regenerated agent? The influence of warm mixing agent and old material content on the transfer degree of old asphalt is found out, and the influence law and degree of different influencing factors on the transfer of old asphalt are found out, which provides the basis for the determination of oil-stone ratio in subsequent mix proportion design. The mixing sequence was studied by macro mixing sequence and different asphalt mixture mixing sequence at home and abroad. The macroscopical mixing sequence does not form the specimen, and the amount of transfer asphalt is used as the evaluation index. The mixing sequence of the mixture was compacted by Marshal method, and the physical and mechanical indexes of the specimens were used as the evaluation basis. The results showed that the test results of the two methods were consistent. It is suggested that the mixing sequence stipulated in the domestic specification should be adopted when mixing the recycled mixture with warm mix in the future. The optimum oil-stone ratio of different old materials was determined, and the road performance of the mixture was studied under the optimum oil-stone ratio. The results showed that with the increase of the old material content, the law of hot mixing and warm mixing was different. The optimum content of the old material was determined to be 20%.
【學位授予單位】：長沙理工大學
【學位級別】：碩士
【學位授予年份】：2013
【分類號】：U414

【參考文獻】

相關期刊論文 前10條

1 蘇忠高;燃燒法與離心法測定瀝青混合料中瀝青含量試驗研究[J];福建建設科技;2005年01期

2 徐世法,顏彬,季節,高原;高節能低排放型溫拌瀝青混合料的技術現狀與應用前景[J];公路;2005年07期

3 唐秀明;;瀝青混合料馬歇爾設計方法與GTM設計方法的對比研究[J];公路;2009年03期

4 侯蕓;魏道新;田波;劉永祥;;瀝青混合料油膜厚度計算方法[J];交通運輸工程學報;2007年04期

5 楊毅文;馬濤;卞國劍;金晶;黃曉明;;老化瀝青熱再生有效再生率檢測方法[J];建筑材料學報;2011年03期

6 徐磊;影響燃燒法測定瀝青含量的因素分析[J];山西建筑;2005年23期

7 秦永春;黃頌昌;徐劍;徐長奎;蘇玉昆;;溫拌瀝青混合料技術及最新研究[J];石油瀝青;2006年04期

8 蔡春華;曹亞?wèn)|;嚴軍;柴平;;溫拌瀝青混合料的應用研究[J];上海建設科技;2006年06期

9 丁錄玲;黃曉明;;瀝青再生劑擴散機理與擴散模擬試驗研究[J];交通科技;2009年05期

10 宋兆勝;;燃燒爐法測定瀝青含量的優點以及在實際生產中的應用[J];煙臺職業學院學報;2010年02期

相關博士學位論文 前5條

1 劉建勛;溫拌瀝青混合料施工關鍵技術研究[D];長安大學;2010年

2 任拴哲;瀝青路面廠拌熱再生及其設備關鍵技術研究[D];長安大學;2008年

3 蘆軍;瀝青路面老化行為與再生技術研究[D];長安大學;2008年

4 耿九光;瀝青老化機理及再生技術研究[D];長安大學;2009年

5 李平;基于膠漿特性的瀝青混合料設計[D];長安大學;2007年

相關碩士學位論文 前8條

1 孟良;溫拌瀝青混合料使用性能研究[D];哈爾濱工業大學;2011年

2 侯睿;瀝青抽提方法評價與就地?zé)嵩偕�技術研究[D];東南大學;2006年

3 楊樹人;溫拌添加劑對瀝青和瀝青混合料性能的影響[D];重慶交通大學;2008年

4 高艷娥;廠拌熱再生瀝青混合料設計研究[D];長安大學;2008年

5 侯月琴;溫拌瀝青混合料性能研究[D];長安大學;2008年

6 夏漾;Sasobit~（？）溫拌瀝青混合料設計與使用性能[D];湖南大學;2009年

7 吳學文;溫拌瀝青混合料性能研究[D];長安大學;2009年

8 章順風;Evotherm溫拌再生瀝青混合料技術研究[D];湖南大學;2010年

本文編號：2492169