發布時間：2018-07-24 20:20

【摘要】：傳統變電站高壓側無功集中補償與諧波治理方法接入點電壓等級高,結構復雜、成本昂貴;而采用低壓用戶側就地補償,裝置安裝分散、利用率較低且缺乏有效的協調,控制不當易帶來新的電能質量問題。配電變壓器集成化靜止補償技術(Distribution Transformer STATCOM,DT-STATCOM)將配電變壓器繞組作為電力補償裝置的接入點,降低了補償裝置的耐壓要求,兼有集中補償?shù)男Ч?但是在裝置拓?fù)浣Y(jié)構、接入方式以及控制策略等方面仍有待進一步研究。本文以配電網電能質量綜合治理為目標,提出了采用配電變壓器高壓側繞組中心抽頭集成方式的級聯型DT-STATCOM,并對無功、諧波和不平衡補償控制方法展開深入研究。首先,構建了級聯型DT-STATCOM系統結構方案。根據配電網實際情況,采用Dyn型配電變高壓繞組中心抽頭集成方式、級聯H橋拓?fù)浣Y(jié)構和LC輸出濾波器構成DT-STATCOM系統。建立了各部分的數學模型,分析了補償注入電流對變壓器繞組電流分布及高低壓側的影響,建立了級聯型多電平變流器狀態方程,分析了由LC輸出濾波器和變壓器抽頭漏抗組成的緊湊型LCL結構的濾波特性,驗證了系統可行性。然后,研究了無功電流補償、諧波電流補償及無功諧波綜合補償控制方法。基于瞬時無功理論,對適用于跨端口補償?shù)臒o功及諧波電流檢測方法開展了研究。提出了一種PI控制與PR控制相結合的諧波與無功綜合控制策略。采用載波移相SPWM技術進行指令電流跟蹤,分析了其調制原理、數學模型及傳輸特性。搭建Matlab/Simulink仿真平臺,進行仿真實驗,驗證了上述方法的有效性。最后,針對三相不平衡負載,研究了負序電流補償控制方法及其與無功電流補償相結合的綜合補償控制方法。針對不平衡補償對級聯型變流器各相橋臂有功輸出的影響,指出了不平衡補償?shù)挠行Х秶�。研究了跨端口的�?fù)序電流檢測與控制方法和直流電容均壓控制方法,并進行了仿真實驗,驗證了上述方法的有效性。
[Abstract]:Traditional reactive Power compensation and Harmonic treatment method for High Voltage side of Substation access Point has high voltage grade, complex structure and high cost, while local compensation with low voltage user side is used, the installation is dispersed, the utilization ratio is low and there is no effective coordination. Improper control is easy to bring about new power quality problems. The integrated static compensation technology of distribution transformer (Distribution Transformer STATCOMDT-STATCOM takes the winding of distribution transformer as the access point of the power compensation device, which reduces the voltage requirement of the compensator and has the effect of centralized compensation. Access methods and control strategies are still to be further studied. In this paper, a cascade DT-STATCOM-based DT-STATCOM-based control method for reactive power, harmonic and unbalanced compensation is proposed, which adopts the integrated mode of central tap of high-voltage side windings of distribution transformers, aiming at the comprehensive control of power quality in distribution networks. Firstly, a cascade DT-STATCOM system architecture is constructed. According to the actual situation of distribution network, the DT-STATCOM system is composed of Dyn type distribution transformer high-voltage winding center tap integration mode, cascaded H-bridge topology structure and LC output filter. The mathematical model of each part is established, the influence of compensating injection current on the current distribution of transformer winding and the high and low voltage side is analyzed, and the state equation of cascaded multilevel converter is established. The filter characteristics of compact LCL structure composed of LC output filter and transformer tap leakage reactance are analyzed and the feasibility of the system is verified. Then, the reactive current compensation, harmonic current compensation and reactive harmonic comprehensive compensation control methods are studied. Based on instantaneous reactive power theory, reactive and harmonic current detection methods suitable for cross-port compensation are studied. An integrated harmonic and reactive power control strategy based on Pi control and PR control is proposed. The modulation principle, mathematical model and transmission characteristics are analyzed by using carrier phase-shifted SPWM technique to track the command current. The Matlab/Simulink simulation platform is built and the simulation experiments are carried out to verify the effectiveness of the above method. Finally, the negative sequence current compensation control method and the integrated compensation control method combined with reactive current compensation are studied for the three-phase unbalanced load. Aiming at the influence of unbalanced compensation on active power output of each phase bridge arm of cascade converter, the effective range of unbalanced compensation is pointed out. The negative sequence current detection and control method and the DC capacitor voltage sharing control method are studied, and the simulation experiments are carried out to verify the effectiveness of the above methods.
【學位授予單位】：華中科技大學
【學位級別】：碩士
【學位授予年份】：2015
【分類號】：TM63;TM714.3

【相似文獻】

相關期刊論文 前10條

1 楊曙杰;;級聯型機組線速度調節系統[J];電機與控制應用;2007年03期

2 馬春艷;張國榮;王新穎;;級聯型H橋多電平變流器在有源電力濾波器中的應用[J];低壓電器;2012年23期

3 高志剛;李永東;;混合級聯型變換器的新型運行策略[J];電力自動化設備;2011年07期

4 劉丹;;級聯型高壓變頻器控制研究[J];制造業自動化;2010年15期

5 葛俊杰;趙爭鳴;;級聯型電壓自平衡固態變壓器[J];清華大學學報(自然科學版);2013年04期

6 丘東元,張波,潘虹;級聯型多電平變換器一般構成方式及原則研究[J];電工技術學報;2005年03期

7 李和明;王毅;石新春;朱凌;;混合級聯型多電平變頻器拓?fù)浣Y(jié)構研究[J];中國電機工程學報;2006年02期

8 江友華;方R，

本文編號：2142547