發布時間：2019-01-30 11:56

【摘要】：為探究鍛造比對H13模具鋼晶粒組織遺傳性的影響,在實驗室條件下對H13模具鋼進行真空冶煉,并加工成鍛造比不同的鍛件。觀察鍛造前后、不同鍛造比下以及鍛件在進行860℃等溫球化退火后的金相組織變化。研究結果表明:鍛造比為1時,經等溫球化退火后H13模具鋼晶粒保持了原試樣的組織形態,具有明顯的遺傳現象;隨著鍛造比的增大,晶粒度增加,晶粒細化,晶粒組織的遺傳性減弱;當鍛造比為4時,晶粒度達到8.1,達到超細晶粒等級,晶粒組織的遺傳現象基本消除;隨著鍛造比的增大,晶粒破碎明顯增加,弱化了其組織的遺傳性。
[Abstract]:In order to investigate the effect of forging ratio on the grain structure and heredity of H13 die steel, vacuum smelting of H13 die steel was carried out under laboratory conditions, and forging parts with different forging ratios were obtained. The microstructure changes of the forging at 860 鈩，

本文編號：2418104