發布時間：2018-04-10 11:37

  本文選題：橋面鋪裝 + 細粒式SMA��； 參考：《重慶交通大學》2014年碩士論文

【摘要】：橋面鋪裝層作為橋梁行車體系的重要組成部分，，其質量的好壞對于行車對橋面板的荷載沖擊和滿足行車的安全性與舒適性以及對橋梁結構的保護具有至關重要的影響。橋面鋪裝層應具有足夠的強度和良好的整體性，并具有足夠的抗裂、抗沖擊和耐磨性能等，但在實際工程中，為了減輕橋梁荷載和需維護工程，在特殊情況下需要采用厚度更小的進行橋面鋪裝，但此薄層鋪裝技術還處于研究試驗階段。也正是因為處于試驗階段且采用何種更加細粒式的鋪裝材料進行薄層加鋪成為了本論文的研究重點，也在一定程度上使得本論文更具挑戰性和艱巨性。 主要研究內容及成果：針對薄層鋪裝的特殊要求，通過對現有橋面鋪裝的病害分析，對薄層鋪裝對防水粘結、細粒式改性瀝青混合料類型及薄層施工技術展開了研究；研究采用了溶劑型AMP-100和均相橡膠瀝青以解決薄層鋪裝與水泥混凝土橋面板之間的層間防水粘結問題，通過性能對比研究，采用均相橡膠瀝青作為防水粘結材料；以直投法的瀝青混合料改性技術解決小規模生產中的瀝青改性問題；選用了細粒式SMA-5解決薄層鋪裝施工中的最大粒徑問題，采用貝雷法對級配進行優化設計，得到了骨架密實結構以及考慮鋪裝層厚度變化對瀝青混合料力學和路用性能的影響確定了最佳鋪裝層厚度為30mm；比較系統地研究橋面鋪裝施工工藝的基本要求和橋面板處理的方法，以及對同步熱預拌碎石防水粘結層和SMA橋面面層鋪裝在施工過程中出現的常見問題進行了研究與總結。
[Abstract]:As an important part of the bridge driving system, the quality of bridge deck pavement has a vital impact on the impact of traffic load on the deck, safety and comfort of driving and the protection of bridge structure.Bridge deck pavement should have sufficient strength, good integrity, and sufficient anti-cracking, impact and wear resistance, etc., but in practical projects, in order to reduce the bridge load and maintenance works,In the special case, the bridge deck pavement with smaller thickness is needed, but the thin layer surfacing technology is still in the stage of research and test.It is precisely because of what kind of finer grain paving material is in the experimental stage that it becomes the focus of this paper, and to some extent makes this paper more challenging and arduous.Main research contents and achievements: according to the special requirements of thin layer pavement, through the analysis of the existing bridge deck pavement disease, the thin layer pavement to waterproof bond, fine grain modified asphalt mixture type and thin layer construction technology were studied.Solvent-based AMP-100 and homogeneous rubber asphalt are used to solve the problem of interlayer waterproof bond between thin layer pavement and cement concrete bridge slab. Through performance comparison, homogeneous rubber asphalt is used as waterproof bond material.The bituminous mixture modification technology of direct casting method is used to solve the problem of asphalt modification in small-scale production, the fine grain type SMA-5 is used to solve the maximum particle size problem in thin layer pavement construction, and the method of Bayley is used to optimize the gradation design.The optimum thickness of asphalt mixture is determined to be 30mm considering the influence of the thickness of pavement on the mechanical and road performance of asphalt mixture, and the basic requirements of bridge deck pavement construction technology and the bridge pavement construction technology are systematically studied.The method of panel processing,The common problems in the construction process of waterproof bonding layer and SMA bridge deck pavement of synchronous hot ready-mixed crushed stone are studied and summarized.
【學位授予單位】：重慶交通大學
【學位級別】：碩士
【學位授予年份】：2014
【分類號】：U443.33

【參考文獻】

相關期刊論文 前7條

1 姜治偉;翟世通;于曉峰;;環氧瀝青水泥混凝土橋面防水粘結層性能研究[J];城市道橋與防洪;2010年06期

2 沙慶林;SAC和其他粗集料斷級配的礦料級配設計方法[J];公路;2005年01期

3 沈金安;美國的SMA配合比設計方法[J];國外公路;1998年05期

4 董善一;祝海燕;郝海龍;;高速公路橋面鋪裝技術研究[J];公路交通科技(應用技術版);2010年05期

5 羅立峰,鐘鳴,黃成造;橋面鋪裝設計理論的研究[J];華南理工大學學報(自然科學版);2002年04期

6 李建軍;薄層瀝青混凝土罩面在高速公路養護上的應用[J];交通標準化;2004年05期

7 劉朝暉,黃云涌,秦仁杰;南方炎熱地區重交通高速公路SMA配合比設計[J];石油瀝青;2004年02期

本文編號：1731037