發布時間：2018-11-08 12:11

【摘要】：隨著智能電網進程的加快,電力通信網絡服務面臨從SDH技術向IP分組技術的升級。大顆粒、多類型網絡業務的出現,迫使以時分復用為核心的電力通信傳輸網向統計復用進行轉變,這就為PTN技術提供了廣闊的應用前景。通常情況,繼電保護和安全穩定控制等電力系統實時性業務采用時分復用技術來構建傳輸通道,此類業務對時延的要求極高,這對傳輸通道的可靠性和實時性提出了挑戰。PTN承載此類實時性業務需要具備充分的理論支持和充足的仿真數據支撐。以往對于PTN網絡實時性業務傳輸時延的研究,大多以網絡測試為主,較少出現的理論研究也沒有考慮傳輸時延的隨機性問題和時延抖動問題。本文采取數值仿真的方法,深入研究了實時性業務的傳輸時延問題。建立了PTN分組傳輸?shù)碾S機時延模型,該模型可以表示隨機傳輸時延概率分布,并可以研究分組封裝尺寸對傳輸時延特性的影響。提出了隨機封裝和固定封裝兩種分組封裝模式,分別建立了單節點和串聯路徑端到端時延抖動數學模型。定量研究了背景流量、網絡節點數量、路由器吞吐量等參數對時延抖動的影響程度,對比分析了兩種封裝模式的優缺點。為了驗證時延抖動數學模型的正確性,編程實現了時延抖動模型的蒙特卡羅仿真。數值仿真結果表明,隨著分組封裝尺寸的不斷增加,隨機傳輸時延概率呈現快速增長的趨勢。背景流量對隨機封裝模式影響較大,對固定封裝模式影響很小。節點數量的增多會顯著增大時延抖動。時延抖動隨路由器吞吐量的增加而減小。在網絡參數均相同的條件下,固定封裝模式的時延抖動值更小。蒙特卡羅仿真驗證了時延抖動模型的正確性。采用非結構化封裝的實時性業務,當封裝數量處于16~32區間時,具有良好的時延特性。通過控制傳輸通道參數,能夠有效減少時延抖動,從而為宿邊緣路由器去抖動設置提供依據。在絕大多數情況下,固定封裝比隨機封裝擁有更好的穩定性和抗時延抖動能力。本課題的研究成果為PTN承載TDM業務提供了理論支持,在改善電力通信實時性業務傳輸時延方面具有一定的技術指導意義和工程參考價值。
[Abstract]:With the acceleration of smart grid process, power communication network services are facing upgrading from SDH technology to IP packet technology. The emergence of large particle and multi-type network services forces the power communication transmission network with time division multiplexing as the core to change to statistical multiplexing which provides a broad application prospect for PTN technology. In general, the real-time services of power system such as relay protection, safety and stability control adopt time-division multiplexing technology to construct transmission channels, which require very high time delay. It is a challenge to the reliability and real-time of the transmission channel, and it is necessary for PTN to carry such real-time services with sufficient theoretical support and sufficient simulation data support. In the past, most of the researches on the real-time transmission delay of PTN network mainly focused on network testing, and the few theoretical studies did not consider the randomness of transmission delay and the problem of delay jitter. In this paper, the transmission delay of real-time traffic is studied by numerical simulation. The random delay model of PTN packet transmission is established. The model can represent the probability distribution of random transmission delay and study the effect of packet package size on transmission delay characteristics. Two packet encapsulation modes, random package and fixed package, are proposed, and the mathematical models of end-to-end delay jitter of single node and series path are established respectively. The influence of background traffic, number of network nodes and router throughput on delay jitter is quantitatively studied, and the advantages and disadvantages of the two encapsulation modes are compared and analyzed. In order to verify the correctness of the delay jitter mathematical model, Monte Carlo simulation of the delay jitter model is programmed. The numerical simulation results show that the probability of random transmission delay increases rapidly with the increasing of packet package size. Background flow has a great influence on random packaging mode, but little effect on fixed packaging mode. The increase in the number of nodes will significantly increase the delay jitter. Delay jitter decreases with the increase of router throughput. When the network parameters are the same, the delay jitter of fixed encapsulation mode is smaller. Monte Carlo simulation verifies the correctness of the delay jitter model. The real-time service with unstructured encapsulation has good delay characteristics when the number of packages is in the range of 16 ~ 32. By controlling the transmission channel parameters, the delay jitter can be effectively reduced, thus providing the basis for setting up the dejitter of the host edge router. In most cases, the fixed package has better stability and resistance to delay jitter than random packaging. The research results of this paper provide theoretical support for PTN carrying TDM services, and have certain technical guiding significance and engineering reference value in improving the transmission delay of real-time power communication services.
【學位授予單位】：華北電力大學
【學位級別】：碩士
【學位授予年份】：2017
【分類號】：TN915.853;TM73

【參考文獻】

相關期刊論文 前10條

1 董正坤;胡立章;孫翠英;劉芳;;分組傳輸網(PTN)在電力系統關鍵業務的應用分析[J];河北電力技術;2016年04期

2 李建明;劉媛;沈晗陽;姚慶;朱國威;王先培;;基于2M業務的電網保護恢復機制研究[J];電力系統保護與控制;2016年16期

3 郭晉祥;李洋;張麗霞;段敬;孟亞寧;;TDM+分組傳送業務隔離度算法研究[J];光通信研究;2016年03期

4 高強;尹永飛;;PTN技術傳輸繼電保護業務若干問題的研究[J];電力系統保護與控制;2016年08期

5 楊卉卉;張華年;袁海濤;李繼晟;;基于PTN網絡的配電網區域保護控制系統研究及應用[J];供用電;2016年03期

6 張合明;魏勇;許俊現;林榕;楊曉偉;;PTN技術在河北電力通信網的建設與應用[J];河北電力技術;2015年06期

7 許俊現;高會生;汪洋;;用于線路縱差保護的PTN時分復用業務時延分析[J];電力系統保護與控制;2015年23期

8 高會生;汪洋;;PTN業務隨機時延對差動保護同步性能的影響分析[J];電力自動化設備;2015年07期

9 魏勇;汪洋;張合明;楊會峰;王妙心;;電力分組傳輸網時延特性測試研究[J];電力信息與通信技術;2015年03期

10 高會生;馬博洋;;一種基于概率分布的縱聯差動保護通道時延模型[J];電力系統保護與控制;2014年17期

相關博士學位論文 前1條

1 曹暢;MPLS-TP網絡的多業務傳送特性和本地保護技術研究[D];北京郵電大學;2012年

相關碩士學位論文 前2條

1 董雯;基于排隊理論的通信網絡時延抖動建模與性能分析[D];吉林大學;2015年

2 馬博洋;基于PTN的繼電保護通道傳輸時延特性研究[D];華北電力大學;2015年

，

本文編號：2318471