發布時間：2018-12-08 09:51

【摘要】：建立了LiCl溶液再生過程的數學模型,通過模擬分析,得到了溶液再生量、溶液溫度和溶液濃度隨時間的變化規律。以平均再生量為評價指標,對LiCl溶液的再生性能進行了實驗研究。分析了熱源溫度、溶液濃度、溶液初始溫度、再生壓力和冷水溫度5個因素分別對溶液再生性能的影響規律。實驗結果表明:溶液濃度和再生壓力對溶液再生性能影響顯著,冷水溫度對溶液再生性能的影響最小。在設定的標準工況下,再生壓力為4k Pa、溶液中LiCl質量分?jǐn)?shù)從28%增大到34%時,平均再生量由20.45g/(m~2·s)減小至7.44g/(m~2·s);再生壓力從4k Pa升高至10k Pa時,平均再生量由15.33g/(m~2·s)降低至1.92g/(m~2·s)。最后,以溶液溫度和溶液濃度作為對比目標參數將模擬結果和實驗結果進行了對比分析,結果表明,實驗值與模擬值符合較好。
[Abstract]:The mathematical model of the regeneration process of LiCl solution was established. By simulation and analysis, the variation of solution regeneration amount, solution temperature and solution concentration with time were obtained. The regeneration performance of LiCl solution was studied with the average regeneration quantity as the evaluation index. The effects of heat source temperature, solution concentration, solution initial temperature, regeneration pressure and cold water temperature on the regeneration performance of the solution were analyzed. The experimental results show that the concentration of solution and the pressure of regeneration have significant effects on the regenerative energy of the solution, while the temperature of cold water has the least effect on the regeneration performance of the solution. When the regeneration pressure of 4k Pa, solution was increased from 28% to 34%, the average regeneration rate decreased from 20.45g/ (mt2s) to 7.44g/ (mt2 s);) under the standard operating conditions. When the regeneration pressure increased from 4k Pa to 10k Pa, the average regeneration capacity decreased from 15.33g/ (mc2s) to 1.92g/ (mt2 s). Finally, the simulation results are compared with the experimental results using the solution temperature and the solution concentration as the target parameters. The results show that the experimental values are in good agreement with the simulated values.
【作者單位】： 天津商業大學天津市制冷技術重點實驗室;鄭州宇通重工有限公司;
【分類號】：O645;TB4
，

本文編號：2368146